Recent content by abced123

The washer finished previous cycle completely, then I have a very weird problem as : - While plugging , the washer shows no LED at all no matter what button is pressed. I try to swap both motor and machine control boards that I bought and nothing is on still. LED pannel is working fine with...

fixed it fixed it , the relay sodering joint was cracked when I examined it closely

Basically, machine was working fine after I changed and modified the leveler from more than one year ago. Last week, it dispensed water then just stop, no nutate or spin at all while all LED still lit. I tried to run all diagnostic tests, LED showed fine, but no nutation or spinning again. Upon...

I have a question related to the u join boot. Is there supposed to have grease inside around the rubber black O ring from picture ? Because I remember when I changed the leveler, I saw a lot of some kind of grease there and I thought it was formed by water+ dirt so I cleaned it real dry. Thanks,

@yogitunes : Mine looks like below, so is it 1st or 2nd gen? I have not replaced both motor/machine boards, just do the grounding. During the last week, unplugging part helped on the first wash/load, so I washed like one load per 2,3 days. But, today after unplugging for 4,5 days the first load...

Thanks for the reply. Yah, it s really pissed off when parts do not die completely ... very difficult to troubleshoot. You are very correct about the unplugging part. If I unplugged for more than few hours, then the first load ran perfectly; but 2nd and more will stall/stuck as described...

Here is the details: This machine was working fine till few months ago, it nutated but did not spin at all. Upon taking the inner washer apart, I found out the plastic ring under/in the leveler got broken. So, I replaced with a new leveler; then problems started. It got stuck at any...