Recent content by brandman

I’ll probably keep both intact but it’s good to know I can swap most parts …. I’m assuming the 21 also has the single rinse which I have not had anything come out dirty after washing unless it was a pot that had burned on food and was washed with the quick cycle … which in my opinion is way too...

I’m not too sure on the history except that they apparently were made In don mills Ontario

The guy who I bought it from was an investor that bought this condo to flip it so he’s not sure much on the history of it …. The console is a little beat up up close which sucks but other than that it’s mint

Here’s my newest find that I picked up over the weekend. I had to drive two hours to get it, but it was well worth it. The console is a little beat up from people cleaning it but the inside still smells like new dishwasher, and there was no rust except for a little bit around the rinse aid...

Thanks ! I’m going to try to finish putting it back together today. I have to get a new retaining screw for the top of the motor shaft because it looks like it got ground down.

Hey did you get a chance to take a look at the pictures? I included still trying to figure out how to put this thing back together

Ok so this is what I had for washers sitting on my workbench I wish I would’ve taken pictures as I took it apart, but this is what I’m left with. I’m assuming that the thick one that I’m holding is the first one that goes on. .. but then my question is where did the other three go?

Yes I’ll send pictures of all the washers I have tonight ….

Ok so here’s the problem….. i had a bunch of those washers on my bench when I took it apart and I don’t remember where the tiny flat ones go and the one thick one goes . I know some of them go under the seal kit and some go on the upper part near the retaining screw

Hey all I’m in the process of rebuilding the pump in my Kds 18 . Bought a new seal kit on eBay. .. want to go and put it all together and realize that I need a touch/clear gauge to stack the washers on the motor shaft …. PN … TL-91043 Can anyone tell me the dimensions of said gauge ? The...

Hey, sorry for the late reply. I had a super busy weekend. I am located in London Ontario Canada.

Let me know what colour kick panel you have and what it would cost to ship I am interested

What colour would it be?

Ok thanks for this info

Looking for a bottom door panel to fit this dishwasher it’s the panel that’s about 8 inches tall below the door