Recent content by ct

Replaced the switch and the machine is working properly now.

Thanks everyone for the advise. Ordered the part and will be delivered this Wednesday. .....will post update.

I found two whirlpool part numbers that both appear to be a replacement for the Kenmore switch. They are WI0339229 as DADoes posted above and WI0820051...Is it correct to assume either one will work?

It looks like I can get an OEM Whirlpool for the same or less than the other brand. Probably better to go that route.

Went through the different types of settings and they all seem to work, but not filling with enough water in the large load, hot water comes on when selected..... This appears to be the right selector switch: ForeverPRO W10820051 Switch-Wl for Whirlpool....is ForeverPRO a good brand? Sells on...

Will do a more in-depth check as Dadoes suggested above. Thanks.

I moved the load size selector switch back and forth and it initially worked, but when set to large load it didn't fill all the way and in the second rinse of the cycle the water didn't come on at all. I went back and moved the switch back and forth a few times and the water fills again but not...

These are the controls on the washing machine. It's an older one.

Where is the water pressure switch? I'm pretty now to this......thanks.

I have a Kenmore model # 110 22422 100, that was working great until a couple of days ago when all of a sudden the water didn't turn on and the machine went straight to agitation. Any ideas on what might be wrong? No water comes on at all. Thanks, any help appreciated.

Interesting about the self-leveling. When I first got the machine and checked whether it was level, it was reading about an eighth of an inch off - both forward and sideways...but the machine worked fine, so I didn't bother with it - figured it was close enough. But, after the off balance issue...

So I think the issues have been resolved. I took the tub out and washed the outer plastic shell and the inner porcelain tub. There was caked on mold, dirt, lint, and who knows what else. For a good percentage of the porcelain tub surface, the little holes that water passes through were plugged...

I haven't found anything obvious flapping around. Looking into what a balance ring is. Is there a way to run the spin cycle with the case off the washer.....seems there would be a much better view of what is happening if the tub is fully exposed. Saw some youtube videos where the case was off...

I made a video of the machine and what it's doing when empty during the spin cycle. Hopefully the link to the youtube video works.

The serial # is CM096229, so the date of manufacture is 2002. Will run a load today and see what happens. I looked at the springs and they are all in place and no obvious problems, but don't know if they are maintaining proper tension. Did some reading online and there are some plastic pads, 3...