Recent content by deconstruction

6033G motor brushes Thank you for the advice. It occurred to me later that the problem seems only to be that the new brush-unit will not lock in place. This is caused by the length of the wings. Otherwise the fit seems to be good (and all I have to do is push in the little tab to allow the...

6033G motor <span style="text-decoration: underline; color: #0000ff;">sesteve</span> what kind of photographs of the motor do you want?

6033G motor So, after a pause of a few weeks I have had another go at the machine. The new carbons seem not to fit. The basic design / form is very similar but there are several detail differences. At first I thought that it was only an updated design but there is a problem: they slide into the...

6033G motor Thanks for the advice. I decided to risk a pair of carbons offered on EBAY (not expensive). And one evening this week I might manage a photograph of the motor (the machine is now wrapped up again so that birds do not get into it ).

6033 brushes Then even if they still work I should replace them. These - from gcr-suffolk and ebay - look right but Servis is not listed, only Creda, Electra, Gala, Hotpoint etc. Can anyone confirm if these are suitable or, if not, a part reference number for the correct carbons?

6033G motor brushes I removed the motor to examine the brushes. Each brush has at least 5mm of the carbon rod protruding and the spring loading works. No sign of burning.

6033G motherboard Included in this post are photographs of the front and back of the motherboard. What kind of damage should I be looking for? Next job, examine the carbon brushes in the motor.

6033G F4 Thank you for the suggestions. I do not have a motor for 6035, sorry. I will have a look at the PCB and report back here. Do you mean the brushes of the main motor? It does revolve the drum a little, without unpleasant noises.

AEG Turna S Thank you both for the information, very useful

Does anyone have technical information (e.g. technical parts drawing) of the drain-pump used in the AEG Turna S ? *  My faithful Turna S has started to leak, it seems through the impeller and I don't want to pull it apart before I know how it is constructed. * which is a Turnamat S but...

AEG Turna S Sure, I will do that     (new thread 71071<span style="font-size: 12pt;"> started)</span>   <span style="font-size: 12pt;"><span style="text-decoration: underline; color: #0000ff;">foraloysius</span>, gegroet!  </span>

AEG Turna S: drain-pump Does anyone have technical information (e.g. technical parts drawing) of the drain-pump used in the AEG Turna S? * My faithful Turna S has started to cry, it seems through the impeller and I don't want to pull it apart before I know how it is constructed. * which is a...

Return... Just found some codes online; could someone confirm if these are correct for the 6033? F1 Water heating error detected For this error code you need to check both the water heater or element and thermistor, the washing machine is reporting a fault on the heating circuit with this...

Return Of The Quartz The project continues. The little rubber-pipe has been replaced and I managed to obtain a new door-seal and fit it (!@#). After putting some water into the drum through the soap-tray to check for leaks there was a dribble from the seal at the drum joint but tightening the...

6033G Good new, I think that I have found a new door seal!