Recent content by fltcoils

The correct part number is: WB30X341 WB30X342 (Please ignore the 541 and 542 numbers as they were in error

Left light switch My Hotpoint has the light switch on the left

Correction to Part Numbers (Perhaps the administrator can correct my original post:) 8" Burner PN WB30X341 6" Burner PN WB30X342 Sorry for the mixup

I enjoy using my Hotpoint range. I recently learned it's design family is the "Total Clean" ranges from Hotpoint and GE. The oven has Teflon panels on the left and right which are removable, and an enamel panel on the floor which is also removable. The burner controls are not multiple...

I am sorry to report my brother has given up on the nachine. Thank you anyhow.

My brother's KUDS30IXBL1 has had difficulty filling after the first garbage flush cycle for about a year. He's been resetting it with the circuit breaker. It finally became ineffective and when he prompted for codes he got a 6-4, 6-2, and 6-1 (newest to oldest). He is puzzled because it does...

I could use the other rack set I could use the other rack set, my KDS 22 has some bad rust on the bottom rack. Let me know if it's still available. thank you

There seem to be few if any The controls for sale seem to be 3 o'clock "off" positon and "push-to-turn" models. (e.g. GE WB24T10029 & WB24T10022) This old 1968 GE/Hotpoint range needs 12 o'clock and NOT "push-to-turn". Anyone have ideas on PN for this and or suppliers? thanks I think it is...

I have good service from my 1968ish HOT POINT 107RB 656J range However when the RR 6" burner burned out, it overtemped the copper arm in infinite the burner control, which now stays on all the time. It's too old for the normal repair parts sites to recognize Does anyone have a lookup Plist...

The nut comes off with finger tension Well done, I'm so glad you got it working. Did I understand correctly, the nut was hard to remove? How is it now? It should come off with finger tension. It sounds like perhaps something was stuck. The mechanism uses the brake cam/spin roll stop to...

clean, lube When I took the clutch apart last summer it was black with oil and grease. I was fairly successful at getting all the gook off of the brake cam and out of the linings, but it was mostly an experiment. It took 3 or 4 soakings in a can of acetone, brass bristle brushing, wiping and...

It was a versa 5dr, yes? Golly I'm glad you got home ok.

my daily driver We use one every day here in our older home. Didn't have the heart to chop into the 1927 cabinates. So a portable works fine. We've not had problems with the top rack getting clear either. Most recent problem was the door switch not wanting to enable operation. common?

Many thanks Thank you so very much. :) I can use my springless bleach dispensor now. I will fabricate a spring. Mark, I'm still imagining you on the turnpike... did you do the same routine with that nissan and the other machines? Committment to ones hobby.

A plug for a favorite cause bleach dispensor spring If someone could measure their bleach dispensor spring it would help with picking out a replacement. spring free length wire size (diam) spring coil diam # of turns That will help get the right stiffness of spring installed. Anyone have one...