Recent content by franklynb

Maiden Voyage Startup Process Stan, When I picked up the machine, I ran it for 5 seconds or so, just to assure that it still rotated. In prep for the "maiden run", I: 1) removed the pump and cleared both ports; blew compressed air through it to try and clear any debris. Once I figure out...

Agitator Port Here's a quick picture of the plug I pulled and used as a temporary oil fill port. I'm sure there is an easier way. It had the side journey of allowing me to tune the agitator a little bit! No doubt there are warnings in the service manual about pulling such a stunt. On day 2 or...

N2L: Ball and Spring Stan, If you look at the side of the transmission, you will find an oval cover held by two screws. In the middle is a serrated cap. I removed that cap after placing the machine on its side. Under the cap is a preload arrangement for the agitator, which I suspect sets the...

Maytag N2L Oil Change I just got an N2L, and have a couple of questions: * does anyone know the oil capacity? I drained it by removing the cover over the agitator ball and spring; put it on its side, and refilled it with mobil synthetic spindle oil, but I'm sure that it should be filled to...