Recent content by guy

It is level. I removed the four shocks. Each feel about the same and have good tension. While I had them removed, the gap was about the same between the tub and front seal. I tilted the back up about 3" to make the tub touch the seal. The new seal measures exactly the same as the original one...

I had to replace the front seal on my washer. It was all torn and a chunk out of it. With the new one installed, the front edge of the tub does not seat in the groove of the seal. The top of the tub is close and the bottom of the tub is 3/4" away. Should I assume the shock mounts need replaced...

Thank you all for your help. You know when the front is on and you are just using the washer you really don't notice the declination. But with the front off it looks broke. I just didn't want to put a $80 boot on two days in a row. Our washer does walk on unbalanced loads. It had not walked...

I have a duet washer that the front load tub seal was chewed up on the last load. Do not know how, but a huge chunk was taken out of it. I have the seal off, but have noticed that the tub hangs lower in the back than the front. Is it to be level and did this cause the tub seal to be damaged? Guy