Recent content by hereitgoes

Low Laundry Definitely do not recommend LOW. I will be lucky if I get that part by Oct 15. I've ordered appliance parts from a number of places over the years and this one is the worst.

Thanks! I found the first one last night. You're right, they seem to be the same even though shipping is different. Taking the plunge!

Here is the pic. This actually seems to be the least expensive of the 5 timers listed for this model. I haven't tested it though (except it still doesn't advance when I wash clothes!) Is it worth trying to replace just the timer if anyone has one or should I just get the whole unit? Monitoring...

Hi yes, I wasn't able to edit the post. It's AWN432SP111TW01 Timer makes sense - I suspected that after looking through the parts list. Thanks!

I bought a Speed Queen top loader in 2014, from what I recall it was the last year before they became computerized. It's a great machine! But the other night we had a storm and it seems to have taken a hit. When I went to use it this morning I found the breaker had popped (the machine was not on...

I've been meaning to reply back - we replaced the defrost timer and thermostat and it seems to have fixed the problem. I'd like to say my energy usage dropped but we went right into tropical weather after that so I can't tell yet. In the meantime it seems my washer was affected by a storm the...

I mentioned the drain because someone said they had a pea stuck in theirs! When the ice melted all the water left the freezer so it did drain out. Defrost sounds pretty noisy, bet it's been awhile since I've heard that correctly =:0

WhiteWhiskers & fisherpaykel WhiteWhiskers When I posted my pic I didn't see yours and when I as scrolling through yesterday I thought it was my own! As you can see mine looked like that. fisherpaykel yes it finally defrosted yesterday. The back was still wet last night in places. I ended up...

Can I reach the drain hose from the inside? It's still melting so I can't see anything yet. Reason I ask is it's a process to get to the back of it. Thanks!

John, Reply #4 I suppose this qualifies as not evenly frosted? There was about an inch of ice along the bottom of the panel on the outside too, gradually thinning and reaching about 3/4 up to the top.

Thanks! I don't think it even has a tray, it was dripping on the floor last night. Light bulb - I didn't think of that. But would the fridge and freezer bulbs be separate? Or would there be one thing that controls them both? I will double check the fans. I never hear anything that sounds bad...

Hi! I have a Kenmore bottom freezer fridge I bought in 2001. #596-69872991 It has recently not been cooling well and that seems to be consistent across both the fridge and freezer compartments. The freezer has also developed some frost on the back wall. Right now the freezer is about 24...

Thanks John! This is the shaft on the worn roller. I think it's hard to tell in the pic but it's a little concave. I'm not sure on the other one yet. Just didn't expect rust on sealed pieces.

Putting it all back together.... These are my new roller shafts. Both have rust marks on them. How to clean if necessary? I didn't even look when I opened the first one.

That's a little funny! So what do dryers have today for baffles?