Recent content by jpaul

Turned the pump on and directed the water back into the tub while it was washing and it worked as it should.

Got the wringers working, washing a test load…I found that there is no drain plate under the rollers...the part that directs the water that's squeezed out back into the tub, it's missing. Other then that seems to be running nicely.

Pump pumps out full force when I first pull lever to on, then trickles out, surges a bit on and off. Water pops up from drain hole. Will drain eventually but very slowly. Will drain nicely gravity wise so maybe the pump wheel not making good contact?

Ok, so it does engage when running. All good, so far.

the E2 won't engage.

Thanks for the welcome, info and tips and the offer for the manual which I have bought. Appreciate it all. The center "bearing" on my friction wheel separated from the wheel on the N2, maybe an epoxy might work. I've been searching but can't find any info on a transmission that won't fully...

Hi, new member here. I have an aqua blue, round, N2L wringer washer that I use once every two weeks for three loads and I run it off a Honda 2000i generator. I found some info about adding oil down the wringer tube until it comes out of a hole in the top of the transmission but I do not see...