Recent content by kendall22

Thank you so much for your reply, Keith. We will check out the snap ring and inspect the groove for damage. Is it worthwhile to fix such an old machine? My husband believes that it is worn out and a waste of time to keep repairing it.

Kenmore 90 Series Washer - Broken Again Hello, After two repair attempts, our Kenmore washer worked for a week and is broken again. The last time, the machine was making a loud noise during the spin cycle. It was also not spinning fast enough so the laundry was coming out too wet. This time it...

Thank you Repairguy and DADoES, It looks like the push buttons are no longer available for replacement (although I only checked partselect.com). Thank you for pointing out the dent in the washer console. Not sure if that would be easy to fix. I am unable to see the wear on the dryer buttons...

People on this site have mentioned that Kitchenaid washers are good machines. What about this set that has push buttons instead of knobs? Is this one of the models that have the slower agitation and a better agitator? Thank you.

You are correct that I messed up the model number. Yes, the black background on the control panel. I didn't realize that so many brands were made by Whirlpool. Good to know. Is this KitchenAid model a good one? KAWS777EQ0. I have attached a photo. Are the push buttons desirable? What about all...

I'm happy to report that our washing machine is working again. Our son thinks that the missing retaining clip might have been the reason it was malfunctioning. Either that or perhaps the transmission wasn't put together correctly the first time. I am very grateful for your assistance. Thank you...

My son told me that he thinks the overflowing problem is a non-issue. He said that the tube was disconnected. He had reconnected it when it overflowed but he thinks that it just overflowed because the pressure in the tube didn't have a chance to build up because the machine was already full of...

And I should add, there appear to be no holes or other damage to the tube. When the machine was operational, it would make a loud clunk sound at the end of the spin cycle. I thought this might be because of a bad motor coupler. The coupler was broken but after we replaced it, the machine still...

The site doesn't allow me to edit my posts. I watched some YouTube videos on overfilling washer problems. I disconnected the tube at the console. I can easily blow through it so it isn't plugged. Does that indicate that the switch is bad?

The rubber tube is attached at the console and at the bottom.

Yes, it was in spin mode. I linked a longer video per your instructions. I don't know if you were able to tell whether the pressure tube is connected to the water level control in the console. It was probably too dark or perhaps I didn't focus on the right area. I have never heard of those parts...

Thank you so much for your reply, Yogitunes. Yes, it kept on filling until it overflowed. It was plugged in. Hopefully tomorrow, I can disassemble the machine again, look for the air dome tube and check whether it is connected on both ends. I don't know how to describe the noise so I made a...

Hello, We have a Kenmore 90 Series washing machine, model 110.209092990. A few weeks ago we replaced the agitator cogs, drain pump and coupler. All was well until a week ago when the machine began to make a clicking sound while spinning. At end of cycle, the laundry was too wet which we figured...