Recent content by nashman50

It looked like a bunch of it was lying under the agitator.

Unfortunately no luck with the repair. My brother and I got it torn down easily enough, but the powdered detergent used by the previous owner rotted the tub out at the bottom under the agitator. Off to the junk pile it went. We ended up with a GE GFW650SSNWW as a replacement. I am quite...

Thanks for your help! I ordered the parts yesterday so we are going to give it a shot.

And do you need the drive bell puller? I have one for a car, but not specifically for a washing machine.

It is basically the same as a newer Speed Queen? I've found some videos online that would probably help.

Is it difficult to replace the main tub seal?

Thank you!

I could probably do it if I could find all of the correct parts, but I've never taken a washer apart before. My dad is a mechanic so most of my experience is on that end of things.

Yes, it's the spin cycle. It does seem to be the main tub seal as well. It's leaking right where the pump attaches.

Hi, Could anyone give a recommendation as to what is making the noise in my Amana LW8203W2 washer in the video linked below? Also, the pump seems to be leaking a little on occasion. Is it difficult to replace? Thanks

I’m honestly not sure. I’ve never seen a Speed Queen even though I’ve always wanted one.

Same machine my parents had growing up! Never thought I would see another.

Finally got my parents to replace the crappy LG top load impeller that has been bad from day one with this one. Just did my first load and it's so nice to have clean sheets again! I hate to admit it, but I think I might like it better than my direct drive Kenmore set.

Just picked this machine up today from a local appliance store for $200, so I thought I would show it here. I have never had a belt drive machine before... so nice and quiet.

Does anyone know anything about the Insignia NS-TWM35W1 from BestBuy? It looks like an odd machine but does at least have a water level selection.