Recent content by rickterry

Hello, This is a photo of the Hot Wire Relay in my oven. As you can see in the picture, there are four terminals. I am getting 240v across the top two terminals. The bottom terminal on the left, (terminal 1) is jumpered from the top(terminal 4) and has 120v on it. The bottom right(terminal 2)...

This is a photo of the Hot Wire Relay in my oven. As you can see in the picture, there are four terminals. I am getting 240v across the top two terminals. The bottom terminal on the left, (terminal 1) is jumpered from the top(terminal 4) and has 120v on it. The bottom right(terminal 2) if the...

Anyone know if this is correct? Thanks!

Combo52 you have been a huge help thru this and I really appreciate it! Here is my thought; I checked voltage across the HW relay, 240 On both sides. But then I thought, since the element will read 120 on both sides because of the current flowing thru the element, what if it is only the...

Ok, here is what I am thinking. After tracing wire, testing voltage, etc., I am only getting 120 on the side of the broiler element that has a yellow wire and a white wire attached.(pic 1),and 32 volts to the other side of the broiler element when turned on. The yellow goes to terminal J of the...

I suspected as much. Since I was never able to get 240 across the terminals. I have not found any burnt wires so far. If it were you, where would you check first, as the most likely suspect? Also, if it matters, the 110v outlet on the left side of the stove, when standing in front has no power...

P7 update and photos Hello again,Thanks for getting back to me.The model number is J 354001 WH13. I am getting 120 on each leg of the element when going to ground, but nothing across the element. I am getting 240 at the terminal block, so incoming is good. I was under the impression that only...

Hello! I am new to this site and I am really hoping one of you can help me. I recently purchased a beautiful P7 stove for $25!! This beauty was immaculate, having been stored for several years. I was told everything worked, and it certainly appeared to be well taken care of. I got it...