Recent content by sarjam

Thank You!!! Everything is back together and the old girl is running again! Went to TSC and bought a 2 1/2 inch pulley with 1/2 inch bore, perfect match 👍🏻 Now to find the plastic/rubber strip that goes around the tub opening, current one is in sad shape lol. Thanks again for the help!

Looks great

So.... Pulley that we recived had too small inner diameter opening. I found this at Tractor Supply - correct measurments, anybody have an idea if this would be ok to use? http://www.tractorsupply.com/tsc/product/phoenix-standard-a-type-3-4-steel-drive-pulley-2-1-2-in-od?cm_vc=-10005

I just picked up a Whirlpool Imperial Seventy circa 1984. But I would much rather have that :)

What a beautiful machine that Norge is. My wife was able to order one through our local appliance guy. Should be in tomorrow. If everything goes well we should be back in business for around $18. 😀

I am a little slow today would anybody happen to have a part number for the non rubber isolated motor pulley? I am new to all this so I apologize in advance

So, ran into a bit of a problem with the Ward 860 washer. Had a burning rubber smell, went under the old girl and found a whole bunch of rubber flakes and chunks amd this pulley fell down. I am assuming there was a rubber bushing of some sort attached to this as it is too big of an opening to go...

My wife and I picked up the last piece of our vintage kitchen appliances. Great condition Hotpoint CTF16ERN fridge. Only piece missing is the tops to the bottom drawers. I have found part # WR32X5154 - can anyone confirm this is the correct part number as I will need 2. Thanks in advance. Bob

Wow! That would have been perfect!

$700 Fridge I went and looked at this fridge as it is along the lines of what my wife and I are looking for. This thing had a few issues. 1. Top freezer door was taped on as the seal did not sit flush 2. Inside top freezer looked melted 3. Freezer side felt cool not cold after running for a...

And so the plot thickens.... I adjusted the door latch, much better. The gasket does in fact seem to be fine. The air leak is actually coming from gap between the door bottom and the lint trap. Not exactly sure how to fix this one lol

Same ones, but the prior owner would not have listed in Tenn - that post looked fake.

Ok, maybe someone knows... Does anyone know if it is possible to adjust the handle? I understand these are prone to leaking air around the door etc, but my wife is finding dryer sheets that made it past the door lol. My first response was to not use dryer sheets, but since I have been married...

I am totally open to diferrent manufactures - would like to keep the colors the same. Too bad you are so far away.

Thanks for the advice 😀 Currently my wife and I are looking for something to match our new/old Frigidaire stove. We did think of having something painted but are more into the all original stuff etc. We have been slowly replacing everything new with old...kind od re-upgrading lol. Here are some...