Recent content by schwab

Thanks but not the part I need...

Looking for 'like-new' dishwasher racks for a vintage KUDA22ST Superba ~1991. I just cannot find the upper rack searching using google.com, searchcraiglist.net, and ebay.com Upper Rack = Whirlpool/Kitchenaid Part # 9741982 Lower Rack = Whirlpool/Kitchenaid Part # 4172117   Suggestions...

Repaired The new part arrived. The washarm support and screen were successfully replaced. Now looking for 'like-new' racks: Upper Rack = Whirlpool/Kitchenaid Part # 9741982 Lower Rack = Whirlpool/Kitchenaid Part # 4172117

My order has shipped with a USPS tracking number....we'll see...next week delivery.

Thanks for the advice... I just purchased a 'Like New' replacement part...details to follow after installation... BTW I have another support I disassembled and it was not amenable to snapping back in place...glue is not a solution for this particular bushing-support assembly either because it...

This photo shows our ~1991 KUDA22ST3 Washarm Spray Support. I believe the lower white plastic piece should fit further down into the gray assembly. It then is held there by the round brass fitting. In the picture it currently appears crooked and loose. If I am correct about the fitment I...

Our dishwasher Kitchenaid KUDA22ST3 is repaired and running again. Details of its failure are in this archived thread: http://www.automaticwasher.org/cgi-bin/TD/TD-VIEWTHREAD.cgi?42234 The dishwasher failed because the control board has P1 and P2 molex plastic female connectors to the...

Thanks for the advice, Ralph. This post is also on the Imperial thread

I own a Kitchenaid Dishwasher KUDA22ST3 with a motor - pump issue. I need to 'bench test' the motor - pump but do not know how to do that (see below) a. It's touch control panel is functioning normally. b. The motor - pump assembly is Whirlpool - Kitchenaid part # 4171577 c. The Kitchenaid...