Recent content by superwash

Thanks John! I just sent you an email. Mike

I was going to replace it with a new one kit if I could locate one.

John - The seal itself is in great shape, but it's missing some of the clips holding it in place. I was given the machine about 3 years ago and it's been sitting in my garage. Bit last week my crappy 7 year old Whirlpool's control board died, so I was going to install the KA. Everything else...

Hi! I posted this on Shoppers Square, but here it is over here. HlI've got a vintage Kitchenaid Imperial dishwasher that needs a new door seal kit (including the clips). I've checked everywhere online (even eBay, where I have been successful in the past), but no one seems to have this part...

Hi! I've got a vintage Kitchenaid Imperial dishwasher that needs a new door seal kit (including the clips). I've checked everywhere online (even eBay, where I have been successful in the past), but no one seems to have this part. So I'm reaching out to the group to see if anyone knows where I...

Someone here in Cape Coral is selling their 1957 Westinghouse laundromat set, in pink ! The seller has a new boot, still in the box. Also has a pump that needs to be installed. https://www.facebook.com/marketplace/item/449466497080057/

Price seems a bit steep, but here it is. https://www.facebook.com/marketplace/item/2993471350965531/?ref=facebook_story_share

The Maytag Pair Work Great! The Maytags are in place and seem to be working fine. I did run a water leak test in the driveway, after getting them off the trailer. The washer perform just fine. I just ran hot water and bleach through the washer. The wash cycle in first spin did perfect. It just...

A few years ago, a friend loaned me a Nuwave induction cooktop. I used it once and was hooked after that. So much so, that 4 years ago I purchased a Frigidaire professional induction range. It was too expensive to install a gas line into the kitchen for a gas range, so this was my alternative. I...

We had one similar to this one when I was a child.

Not so intimidated now. Ha! I just watched a few YouTube videos, and now I'm not so intimidated. It does look pretty easy to check. I'm hoping I don't have to replace them. Thanks again![this post was last edited: 11/28/2021-22:03]

Good-Shephard, thanks for the information about the damper pads. I'm hoping that I can do this, because (at my older age, ha!) it looks intimidating. Anyone living in SW Florida that would like to assist (I would pay you, of course). Thanks!

Good-Shephard, thanks for the information about the damper pads. I'm hoping that I can do this, because (at my older age, ha!) it looks intimidating. Anyone living in SW Florida that would like to assist (I would pay you, of course). Thanks!

They're Home! I picked up the Maytags today. They look better in person than they did from the photos! Both washer and dryer are in mint condition. No scratches dents or rust anywhere . I already did a water leak test in the driveway. The washer agitated and spun the water out without any...

Thanks everyone for the advice! I'm picking them up tomorrow, but they will go in the garage until I can check everything that's been suggested. I'm looking forward to getting rid of the Samsung set.