Search results

Fill the tub with hot water, let it stand 10 mins. then check the speed.

JeffG pegged it. poor vent and a painted surface. repaint and drum and bulkhead good as new

there was a special tool to remove the arm from the wheel. looks like a tie rod end remover.channel locks on the hard edge will remove the arm from the shaft. to remove the entire assembly you are going to have to drop the pump. never liked this design due to mechanism adversely effected by...

as a retired whirlpool factory tech. world washers made you call in sick, if you had them on your route. reliability, was in the toilet, as well as whirlpools bandaid fixes. tub leaks were an everyday occurance, and even with a new tub and cp seal they still leaked. good luck my friend as you...

original pn Q-4688

place a cup of tang powder in it and run it thru a wash. you will be surprised.

the filter in the front blower housing, and not the rear of the drum.

Sorry just re-read your model. the latter applies only to the halo of heat dryer, and not the newer style with filter in the door

Pull the cabinet, remove the drum pulley, then the drum blower wheel. Then remove the drum and look in front of the drum shaft sleeve bearing. you will find 2 o-rings one at the front and another at the rear of the bearings. they usually get brittle from the heat and will squeel. throw them...

rollamatic gm frigidaire, the worst piece of junk frigidaire produced. even the 59' multimatic was better and that is not saying much. None finer than the unimatic.

If I recall right the A4298 was the wringer center post seal, that transitioned to the automatic design. Replaced many of them in the wringers. and early autos. They were included in the stem kit,also.

1st thing that I would think of is the service after the sale. As a retired Whirlpool tech, service is and always will be the major factor in anything that I purchase. Sorry gotta lean with the Kitchen Aid brand in my kitchen.

You message is somewhat vague, the drum is not supposed to turn in agitation, if the agitator will not agitate, more than likely the fibre gear is stripped, and time for a rebuild. Also replace the oring in the trans housing because they get old and form a flat spot snf you will have grease...

One thing you need to check is the length of the spin roller screw. Its the one on the back side that is hell to get to. Pull the front cover off and look. If the screw sticks out about a quarter of an inch you have the revised one. Gm had problems with the screw breaking, and it was a bear to...

Here is what I am going to do. Going to moms this week and will go by the shop and take an inventory of the tools and parts that are left, and post it here next monday or tuesday. Would much rather see them in use that just sitting on my workbwench rusting away. Dad basically hated gm's move...

Have 3 sets, spanners water and oil bellows pliers, plus the pliers used on the one bellows washer with the lip on the bellows. Also a complete set of tools for maytag wringers for sale. Also have the following parts for the unimatic, 4 torque springs, 2 new style oil pumps(piston&spring) also a...

Tilt the washer back, remove the belts, the turn the main drive pulley by hand, this runs the brake cone up away from the bottom of the package. Then use an oiler filled with tranny lube and problem solved.