Search results

It now runs very well, with none of the trace of fan rattle as before.

Was this message on Hoover dryers in the UK? I obtained a new door seal from the supplier in SA, but it must be for dryers with glass in the door. The seal is not tall enough to reach my door and seal it. As the doors with glass have a raised section to retain the glass (the same pressing as...

…and the front.[this post was last edited: 11/27/2013-00:26]

A last look inside from the rear...[this post was last edited: 11/27/2013-00:26]

Rear panel on.

I was able to obtain a new clockwork timer from a firm in South Africa. An electric timer was fitted back in 1991, but I think to enjoy the full charm of these dryers, you should be able to hear it ticking. The company in SA were very efficient and I'd recommend them to anyone. Their page for...

The control panel cutouts can be seen for the various models of washers and dryers.

The screws holding the fan bearing housing in place can be seen.

The motor with both belts installed. The pressure roller can be seen at the other end of the motor applying tension to keep the drum belt tight. The drum belt was new at the last overhaul and is still in perfect condition. The fan belt was replaced a few years ago and is in good condition.

Looking good.

These clever multiple holes allow the fan housing to be moved in and out slightly, to adjust the end float of the drum.

The fan housing back in place.

The drum housing is retained by four screws with these large strengtheners. These screws need to be tight, and unfortunately the original screws strip very easily. They were replaced with ss screws as pictured.

Ready for the fan housing. The rear drum bearing rotates at low speed so I used grease for lubrication.

As mentioned earlier, the cabinet has to be spread slightly to get the drum back in. Towels were used to protect the paint on the cabinet. The 455 is washing a load of towels as a first test of the dryer.

The cleaned up cabinet ready to accept the drum. I removed the broken element insulator and glued it back together with Chemical Metal. I thought it was worth the risk. If it comes apart again now that the machine is back together, it can't do any damage. If anyone has a spare element...

At this point I decided to install the thermostat on the fan housing while it was out. It is retained by a rubber grommet that can be tricky to install.

All ready to go. The felt seal is original and is in very good condition, especially after a good vacuum.

Reinstalling the support bridge for the drum rear bearing.

The fan is very nice cleaned up. Just thinking, that it would make a great clock dial (perfect with 12 blades for the hours) for the Hoover enthusiast who has everything. Hehe.