Search results

I have a 23 series also. The washarm should just pull straight up and off. After that you will see how to remove the filter for cleaning and check for anything else in the tub. Maybe yours has never been cleaned? As far as the air gap is concerned, just google "high loop". The 23 is a good...

Cool! Where did you find all that? Is there any scent?

Hello, I'm trying to locate an agitator cap or fabric softener dispenser for my 1-18 Thanks so much :)

Awesome Thank you Searsbest!! Now l see why it washes so well!

Searsbest Thanks for the info! Do you know what the wash sequence is on a normal cycle? Does it do more than one rinse. The current KitchenAid l have only does one rinse after washing. Does it heat the water? Thanks 😁

Thanks Bob I'm going to pick it up this weekend. Do they have a plastic tub? How about washing performance? Does it have 3 washarms bottom, middle and top? Thanks :)

Is anyone familiar with this model #1698582 Kenmore? Would it be an old Ultra Wash? Thanks :)

Maytag? What happened to your vintage Maytag? Have you thought of looking for a vintage KitchenAid dishwasher? If not, my sister purchased a Whirpool DW from Lowes about a year ago and loves it. It's similar to the one posted by appnut but stainless.

FIXED! Thanks Gentleman! I found a loose connection on the little thermostat wire that's on the blower....I pinched it tight and it now works... Now to work on the gurgling problem. I replaced the flapper in the check valve and it worked for a couple of washes but started gurgling again...

I don't know how to use a mulitmeter. I should have mentioned that the heating element does turn on to heat water and works well for that. Thanks

Thanks Steve!! Is the energy saver button stuck causing the heating element to not come on? *No...it is not stuck and performs like all the other buttons. Are all the wires connected on the dryer housing? *Yes, all wires are connected and look like new...nothing looks burnt Is the element...

I picked up this KDS21 a few weeks ago. It washes well but doesn't dry. Even using a rinse agent my plastic items are still very wet. The flo-thru drying fan IS running during the dry cycle....but the items are not even that hot when finished. Is this the nature of the 21's, or do I have a...

Thanks John. Is this the shaft seal? Do I need to remove the motor to replace the seal? I've never done this before.

I picked up the KUDS22 yesterday. It's in pretty good condition and runs great. Unfortunately after running my first load and sitting for a couple hours there was quite a bit of water on the floor. It appears to be leaking from the top of the motor. The tub seal area feels dry. Looks like its...

I am thinking of getting this to replace my beloved KUDA22 with a bad board. Would this be newer or older than a 22? Hobart motor or Whirlpool? Does it have a 3rd wash arm that rinses the tops of glassware? Thanks :)

I found this board online and the seller says that it's compatible with the KUDA22...even though it's from a KUDA23 which has a different motor, sensors and door switch. It looks similar, but compatible??

Hi John, Thank you for checking, I really appreciate your help. I will keep looking and hopefully something will turn up. Have a great day.

Me :) Does your KUDS-23 look like this? Thank you

Thank you for the suggestion kb0nes. The display was gradually getting dimmer but if I tapped it, it would work for about 30 seconds. Unfortunately it's past the point of no return as the display has been ruined by a leak. I broke a part of the tube used to evacuate it and place it under a...

You've been highly recommended for locating a part I need. I'm looking for the control/display panel for my KUDA22st5 dishwasher. The p/n is 4171266. Thank you!!!