Search results

I am looking to sell my 1953 Frigidaire Unimatic washer I have. The machine did work however I pulled it out of service because something seemed to be going wrong. The agitator sometimes still goes up and down for a little while until the machine reaches full speed spin. I took it out of service...

And here

This is the leak

Here are some photos of what I did. The circled area is where it leaks and the other is my framing Also the door shuts hard and seems to hit on the hing area

Hey guys just wanted to update you. I ended up making a frame out of 16ga steel and bending it in an L and making the frame. Anyway I tested it when it was still a portable and no leaks now that it is installed there are leaks Water is leaking out of the drain area and also the blocks that...

It will not fit with the cabinet on it and I cannot cut anymore to make room because I have plywood on both sides already. With the cabinet off is there some way I could make a base that will support the dishwasher? How was the frame on the non portable ones of the same line?

Hello all it has been quite some time since I was on this site. I recently bought a portable Whirlpool dishwasher with the intent of converting it over to a built in model. I have found out that the conversion kit 569056 is no longer available. What all needs to be done to convert it over and...

I just checked the shift arm and it is free. Also, the solenoid seems to be working properly and fully pulling the arm down when it goes into spin. Most of the time the machine will continue to agitate for a while in spin and then eventually get up to speed, and very rare will it go right into...

Is there anyone that has or knows where I can get a new rubber tub ring seal? Mine is rotted and coming apart in places. From what I can tell it is part 54141 I cannot seem to find it available or on ebay. Thanks

Well I finally got the agitator off! Now how do I get the top of the two tubs off I read about clips but I don’t seem to see any on my machine. Thanks Jesse

*nut

I wasn’t sure if there was another but to take off or if it is just the agitator cap

Here is the top of the agitator that I can’t get off.

I am working on restoring my whirlpool since it needs new bearings anyway. I was wondering if anyone could help walk me through getting the basket out of the outer tub so I can clean and check for rust issues and address them. Thanks for any help in advance!

The machine needs the bearings changed so I figured I would check the out tub for rust and a dress any issues at the same time.

The model number of my machine is LVB5300W1 Any advice or help is greatly appreciated!

The model number and picture of my machine is in thread 78949

Dumb Question I have an older whirlpool washer and I cannot get the agitator out. Is there some sort of trick to it? Also how do you take the tub ring off to get the basket out to clean the outer tub and check for rust

I did not get to check to solenoid shifter yet but I did try to just run spin with nothing in the machine and the agitator goes up and down while it starts spinning and eventually after some speed gets built up it stops moving and gets up to full speed spin

If it were the solenoid would it spin at all?