Search results

The technicians seem to be like photocopier technicians. Only able to replace modules. Although in saying that who wants to attempt to repair a vintage washer. If any of the pieces crumble off then start praying or paying. Imagine funding a replacement motor if you looked at one of the...

Sorry to clarify at the end of a wash cycle, the automatic switch-over from rinsing to spin can depend on the machine detecting the rinse has finished. The rinse portion normally ends with the water being pumped out and the tumbling of the clothes. However, some machines can tumble until "the...

or if one of the breather hoses from the pump to the dispenser is clogged

In some machines spinning does not occur until "it" is sure there is no water in the tub. From the service manual comes this. In order to improve rinsing results, the wash cycle motor continues with its normal agitation during drainage steps until water levels subside and the relevant reset...

So are there TWO sets of brushes? One set for washing and another for spinning?

Does it spin when fully loaded on a spin only cycle?

Are they not just Bosch?

How does the quietness compare to what you previously had? How is the Ultraphase doing at cleaning? Do you miss the orange door button?

Yes Great idea and I've considered the idea too. If you don't like it peel it off

Don't be shy. Take the machine apart. Have a look inside. You will need a T20 torx screw driver and probably a 10mm socket or spanner to undo any door bolts (If your machine is of that generation). Here is a video to watch. F51 is regarded as a pressure sensor fault but in this case was not...

Only one clove of garlic? Really? I do like creamed spinach with STEAK. Will try this recipe. Thank you.

The water level switch responds to pressure changes inside the pressure chamber which is connected to the tub. For it to work properly the hoses and the chamber must be clear. Start there and then turn to the pressure level switch.

Check the hoses are clear If any of the hoses are snotted up then it can think the water is pumped out when there is still water in there. Check the hose from the pump that rises upwards to the detergent drawer. Check the hose that goes from the detergent drawer to the anti-siphon chamber at...

Yuck I cannot bear looking at bag-less vacuum filth containers. I can understand why Miele are wanting to make a bagless. For all the stingy types who gripe about how expensive the genuine replacements bags are. Wish they could focus on making vacuum motors that don't lose power after 2...

Is there a fuse in the small board holding the on-off/door button? Also check that this crud hasn't filled up the pressure tube (Left of your foot in first photo).

Its far easier if you have a spongy board. This can be achieved by having two covers on. I had an awful ironing board to begin with. It was rock hard and too low (I am tall). Bought a used Laurastar with a soft-pressing soleplate and never take it off. Don't have to worry about burning...

Miele dishwasher takes 2 hours 20 mins but it is quiet. I would rather have quiet and long than short and noisy. Miele washing machine takes approximately 1 hour on the typical minimum iron program we use and the results are great and it is quiet too. I would always choose long running times...

Miele ovens feature a heated catalyser to help prevent smells. Do Bosch ovens have such a feature and does it REALLY help with smells? I am not a fan of food smells in the house.

My auto cycle is inclined to skip the prewash. However I don't have poor washing results. Would a tablespoon or two of cocoa convince it to not skip the prewash? Are prewash cycles normally heated also?

I bought a Miele washing machine from a couple who said it was dead. They thought it had faulty electrics. When I was driving home I was filled with dread though. Yes sure enough when I got it home it worked perfectly. They didn't understand that when the door was open the machine was...