Search results

Hi Guys, really appreciate your advice and help. Just took console cover off and there appears to be no linkage between timer and the water level switch, check it out

Two speed timer on GE Filter Flo Hi guys, took the control panel apart this morning to try and see if there was a speed shift that controlled the speed of the timer but couldn't see anything obvious on the timer. Found the schematic document which I will scan later and post if anyone is...

Thanks for that Mark. Spray rinse is great in the GE FF and does shut off the water flow shortly before the spin stops. My Maytag Atlantis has a really short spray rinse, pretty useless. The best spray rinse are in my Fisher &Paykel washers. Both washers have several spray rinses during the...

dials

dials

dials

Hi Tony, this sounds like the most likey cause of the short pump-out/spin time. Where abouts is the speed shift and what does it look lik? How does the washer know when the mini basket is being used? The only things I can see are the mini basket setting on the water level which I think just sets...

Cheers Doug, I might try that. At the moment I am setting the auto extra rinse to do a second deep rinse to ensure the load rinses properly. If I set it to low water level ther is no problem but on high water level it takes too long to empty. It is like the first spin and spray rinse is too...

I hope everyone had a great holiday season. It gave me some time to fix the old GE Filter Flo I got on eBay the other week. Managed to fix rust and leaks in outer tub. Did an empty run first. Works great except that at the end of the washy phase, it pauses, starts to spin and pump out. However...

Another picture, sorry for poor quality

More advice needed re repair to GE filter flo washer I finally managed to get the wash basket out. Two bolts came out relatively easily the third was an absolute bitch and I ended up obliterating the bolt head but at least got it out. Notsure where I can get a replacement bolt, any ideas? I...

basket removal Managed to get the plastic cover off, it was full of crap. Soaking the bolts wirh WD40 before I attempt to remove them. Really worried they may shear off

This is where I am up to now with tub basket removal. I am thinking that the water inlet nozle and the bleach dispenser nozle may get in the way of pulling the tub out? I just cant see how to get the plastic thing off to get to the bolts to remove the basket

Cheers, thank for that. I have been trying to pull this plastic cover off but it wont budge, any tips to help get this off?

Hi there cfz2882, thanks for your advice. I have got the agitator off the spindle relatively easily. I have the top open, where are the three bolts I need to remove? I am guessing underneath the outer wash tub? Cheers Simon

the console

inside

some pictures

Hi Guys, I just picked up an old GE top load washer from EBay in Sydney yesterday. It is a great old machine but when I connected it up it was leaking badly from where the sump enters the outer tub at the bottom. On close inspection there was some rust and a small hole. I have patched the hole...

Thank guys for your replys, much appreciated. Matthew, I really like the look of the Electolux washer range. I think Electrolux took over from zanussi though I think Zanussi still sell in the UK and Europe. Cheers Simon