Search results

Does anyone know if Miele little giants have programming mode? The usual 5 press and hold of start doesn’t work, but service mode does (3 press and hold)

Does anyone know how to read the operating hours in this range of AEGs? I found service mode easy enough but not operating hours.

Hi guys, just wondering if anyone has any ideas to what could be causing this issue. From the very start of drying as soon as the fan reaches its set speed the drum gets pushed back against the tub, with the drum rubbing against the tub and the DD motor basically carving out the metal back...

Managed to find this whirlpool - looks like an older one to the aqua line versions. It’s 1000rpm and fully working for free

Here’s a shot of the inside of the compact LG signature combo - the 2016 design. The auto cleaning fins & filter work well, next to no build up on the fins or duct in a 2021 model, and I saw lots of fluff being pumped out It uses LGs own inverter compressor and I didn’t expect it to have a...

Hey guys, wondering if any of you know what E36-11 or E31-11 is on a new Siemens washer dryer. My sisters 2yr old Siemens started making the error tone really loudly and displayed one of these codes, I know it ended in -11 but am unsure whether the start was 36 or 31. When I went to check the...

Hey guys. Looking for advice on any tips on replacing paddles on an AEG washer. I’m looking to replace the new gen paddles with the old protex generation paddles as they’re much taller. It seems like there’s only plastic clips that hold both versions on but not sure the best way to remove them...

Hi, does anyone know how to enter service mode on a Siemens washer dryer? I’ll insert a picture of what the display looks like. I’ve tried the usual turn to spin, hold spin speed and turn to cycle 3 (being easy care) for this model and it only displays E00 (last error code stored) but...

Hi, I was wondering if anyone knows more about Bosch’s +1/2/3 fine adjusting system. Would this just be a timed phase ran after the relevant drying target is reached or is it actually an adjustment of the sensor like Miele dryers? I’ve noticed diff cycles add different amounts of time for each...

Hey guys, was wondering if anyone had any knowledge on what may be causing my new asko machine to keep storing a E10 fault relating to a water level sensor issue. It never displays the error in normal user mode and I had no idea this was happening until entering its fault reading menus. It’s...