Search results

Ready to Unroll Thanks SteveT. Your advice is beyond invaluable. I am now ready to proceed. I do have enough rolls of thick cork sheeting in my stockpile to make new gaskets, if need be. And I did notice that fragile layer of carbon in that washer sandwich. I'll still need to find a successful...

Replacing Pump Motor Blues SOS. My black enamel 1959 KD-12 finally had its first serious setback after 59 years of service. The pump motor seized with a screech and some smoke. I plan to repair it (bearings, water seals, lubrication, electrical). I started to remove the motor by following the...

Success and Gravity Drains Thank you. Our KitchenAid K-12 now runs perfectly. A full load of dishes came out sparkling. The wash arm rotates robustly and at full speed, and the splashing action is good and strong. All this as a result of cleaning some of parts (wash arm, support housing and...

Bakelite ...is what our support housing is made of. The circular top surface of the support pin is flat and has an inlaid square of brass at its center - about 1/16 inch on each side. I plan to make it a little smoother and examine the wash arm bearing. Last time I looked, there was evidence of...

Washer Arm Design Question We have a pink KitchenAid K-12 dishwasher that came with our 1959 home that we bought a few decades ago. It still works okay, but it should rotate faster. Is there supposed to be a ball bearing or washer at the top of the shaft where the cast iron wash arm sits? I...