Search results

Just checking to see if you got my email Val?.

Email sent. Thank you!

I'll definitely take them! Much better than nothing. :)

Just checking back for an update on potential parts. :)

Excellent! I'd gladly buy them. In fact I'd probably be interested in any of the portable parts you removed from it. As spares to keep mine going.

Hello people! I'm in desperate need of some parts for our beloved KDS-58 portable dishwasher. A few months back I sent the two plastic housing parts from the rear cord and hose areas, to an acquiantance who could 3d print me some new ones. Due to "medical" issues or whatever else, this...

As you said, John, I found some broken plastic in the drain valve.

Thanks John! I'll report back after checking all the lines. I appreciate your expertise! -Matt

I have not had time to check the lines yet but figured I'd get this information while making dinner. I ran a normal cycle with no dishes in the machine. Before hand I filled 1.5gallons and 2gallons of water into the sink and measured the levels. Prewash filled an inch onto the angled plane...

Thanks John! I get these checks done today and report back!

Back when I got the machine it was filling correctly. We are on a fairly new well with digital controller and the water heater is about 10' away from the kitchen faucet. Pretty solid pressure and I removed the flow restrictors from the faucet adapter when we got this thing. I'll pull the...

I flipped the DW on its back and snapped a few photos. Just to confirm what seems obvious to me... The tan colors valve is the inlet (I only see a single solenoid on it). The blue valve is the drain. I moved the drain valve manually and it's smooth operating. Guessing I should pull these...

Thank you! I'll do some digging and post back.

When you say filter I'm assuming you just mean the stainless mesh basket filter? I clean that routinely, except for the fine strand fiberous material that collects into the rolled bottom lip. Seems impossible to get it all out. I have not checked the drain valve, I just had figured if a cancel...

Hello! Well after over a year of trouble free amazing dish scrubbing power, we finally started noticing some issues with our kds-58. It started with the tub sometimes not draining "fully". Then we noticed over the last month that the top rack was not cleaning near as good. Today after a normal...

Thanks! I figured that out after holding it up above the unit haha. Thanks for the response!

Hello!! You all have helped me before when getting my own KitchenAid dishwasher. Now I'm checking one out for a family member. I obtained this unit on a local classified as and have it hooked up & running. 100% of the time there is a light flow of water out of the discharge hose. Also when...

I ended up making my own gaskets for those parts from rubber sheet. I made new screw gaskets and detergent cup gaskets. Worked awesome.

Will do gansky! Thanks sprog! First run down and zero moisture. So we will see how it holds up.

Well I used some jb water weld putty. Scuffed the surface and packed the putty into place. After setting for an hour, I drilled and ran some screws in to set the threads. Allowed it to harden more, sand down, and mounted with new stainless hardware. I also made a new rubber gasket and washers...