Search results

Pew! I noticed after the last cycle that it was a little stinky inside, suspiciously like the garlic jar I washed on Friday. The washer was a really tight fit in the cabinets, so it may not come back out for a few weeks :/ Just ran a sani-cycle, and the final fill appears to be just above the...

Hey Steve! I knew you'd be a font of knowledge. We'll be pulling out the machine soon, since I hear that we put the wrong drain hose on it (corrugated plastic), and I'll test out your suggestions then. I'm going to run a load tomorrow and I'll check the fill levels and let you know how they...

Just noticed... The manual says: "Selecting the Energy Saver button along with any of the 'wash and dry' cycles, will shut off the heating element during the dry portion of the cycle. The fan in the drying system will continue to operate. " So theoretically, I should here a fan. All I hear...

Could be! "Fine spray" is the only way I could think of to describe it... I wasn't expecting the water getting hot to make a noise! Mystery solved :) @turquoisedude: the KDS18 has a Plate Warmer button, but I can see no evidence that it does anything; no warmth in the tub that I can tell. I...

I finally got my KDS-18 installed last week, and have been running it and fixing what I can. I replaced the O-rings in the soap dispenser, which were leaking pretty badly and shorting out the bimetals. Now there is no water in the door at all, but I still have a small leak (two drips during last...

First time poster! I have a KDS18 that I am getting panel frames for, but they haven't arrived yet. I'm about to get some stainless steel cut and thought I would go ahead and have them cut panels for me out of the same stock, but I don't know what the measurements need to be. Can anyone with a...