Help with KDS 18 pump rebuild

[brandman]

Hey all I’m in the process of rebuilding the pump in my Kds 18 . Bought a new seal kit on eBay. .. want to go and put it all together and realize that I need a touch/clear gauge to stack the washers on the motor shaft …. PN … TL-91043
Can anyone tell me the dimensions of said gauge ? The instructions in the service manual are not the greatest

 

[qsd-dan]

I have the gauges for these and they're not necessary if you transfer and stack the original washers on top of the motor shaft. Confirmed this on 4 different 18-20 dishwashers using the gauge set.

 

[Marky_Mark]

I installed a new seal in my KDS-18 and I didn’t have the gauge either. I did wonder if it would all go together ok and work properly without using the gauge. It did indeed go together no problem and it’s still working perfectly a year later.

Mark

 

[brandman]

I have the gauges for these and they're not necessary if you transfer and stack the original washers on top of the motor shaft. Confirmed this on 4 different 18-20 dishwashers using the gauge set.

Ok so here’s the problem….. i had a bunch of those washers on my bench when I took it apart and I don’t remember where the tiny flat ones go and the one thick one goes . I know some of them go under the seal kit and some go on the upper part near the retaining screw

 

[qsd-dan]

There's a thick washer that goes under the drain impeller, that's probably the one you're referring to.

 

[brandman]

There's a thick washer that goes under the drain impeller, that's probably the one you're referring to.

Yes I’ll send pictures of all the washers I have tonight ….