Hi everyone, I recently acquired a Maytag A107 and I noticed it leaked a little bit of water. I took off the front panel to investigate and I watched the whole wash cycle. I realized during the rinse cycle when the washer is spinning fast drops of water gets spit out of the space between the drum and the lid. This sprayed water would normally lands on the front panel and the front lip of the top panel. These water drip to the floor and eventually leak through the front right leg of the washer. I already levelled the A107, I'm just wondering is this small leaking behaviour normal? Did I put too much clothes in my A107 or is there something wrong with my washer?
Maytag A107 spits out water from the top of the drum during rinse/spin cycle
- Thread starter coolgod
- Start date
Help Support :
There is likely something wrong, however, made tags to splash a little bit during the spray rinses, and they also can be oversized and leak a little bit.
I would keep an ion it and see if it keeps doing this and then figure out why it’s doing it.
John
I would keep an ion it and see if it keeps doing this and then figure out why it’s doing it.
John
