Maytag a412 injector valve

Automatic Washer - The world's coolest Washing Machines, Dryers and Dishwashers

Help Support :

fester13

New member
Joined
Aug 20, 2017
Messages
1
Location
Breaux Bridge Louisiana USA
Hello all.
Been incommunicado for several years due to no internet connection, but I moved to the swamp and have a little bit now.

So here goes.
Can someone tell me the purpose and or necessity of the injector valve on a maytag A412. No bleach dispenser or other bells and whistles.
It appears, to me, to be a siphon break or something of the sort.
What exactly does it do? Can it be eliminated and replaced with a straight hose?
This machine is a rust bucket curb score for grubby clothes at my shop.
Please advise.
Thanks in advance.
 
It appears, to me, to be a siphon break or something of the sort.

 

Yep, it also helps regulate the incoming water volume so it doesn't overwhelm and waterlog the tub during the spray rinse in the first spin cycle. Not recommended bypassing it.

 

Is it leaking?
 
Maytag dependable care, washer in the air gap

This device is required by plumbing codes, but the likelihood of it ever causing a problem by not having it is about nothing, yes you can bypass it. Many people did do this if it’s leaking or you just don’t want it.

It does not regulate or control the flow of water into the tub. That was not. Its purpose the flow of water is regulated by the flow washers that are built into the inlet valve.

John
 
Bypassing the injector valve

Thanks,
I figured it was a code thing.
I have the part on order. I just wanted to join the hoses with a piece of tube until it arrives ... unless I just decide leave it out.
The injector valve body/housing started overflowing after I replaced old inlet hoses and cleaned the screens on the inlet solenoids.

Weird, but that was the only change.

Thank again!
 
Quick terminology check:
The original post asks about the injector "valve", but based on the context, I presume they mean the entire assembly. Dan confirms "siphon break", and John confirms "air gap" and the code requirement behind it.

... but from Maytag's naming perspective, the "valve" is a specific part of that assembly. We have the "Injector" (cone shaped plastic bit), the "Injector Valve" (the flexible conical rubber part around it), and the "Injector Sleeve" (the plastic part that catches the sprayed water and directs it to the hose that connects to the wash tub).

Earlier Maytags (I'm beyond my knowledge, Highlander-era?) had just a metal nozzle spraying into a metal catch funnel, without the rubber "valve" part.

Is/was the expanding "valve" part itself actually required for code compliance, or just the air gap? Was there a specific reason or issue the valve was added to resolve?
 
Maytag inlet air gap’s

Hi Dave, good questions the older Highlander, Maytag‘s just had a little copper tube as you mentioned the problem with the system is minerals would build up at the end of the tube and it would spray off to the side and leak, when they put the so-called injector valve in the intention, was to stop leaks, and it worked pretty well, but the little rubber piece would wear out in these and it would leak Also.

Both designs serve the same function and we are required by plumbing codes all automatic washers that are hooked to plumbing, have some sort of air gap built into the fill system.

John
 

Latest posts

Back
Top