All,
Still rebuilding the 1969 Malleys Whirlpool and have a few questions I hope for some guidance on.
1. The agitator shaft is very corroded around the upper bearing. Is this OK to reuse ? Alternatively are replacement agitator shafts available to buy ?
2. The original spin tube had an upper seal for the agitator shaft. The replacement spin tube I bought does not have this seal. Is it required and is it available to buy ?
Pictures attached.
Thanks so much.
Tim


Still rebuilding the 1969 Malleys Whirlpool and have a few questions I hope for some guidance on.
1. The agitator shaft is very corroded around the upper bearing. Is this OK to reuse ? Alternatively are replacement agitator shafts available to buy ?
2. The original spin tube had an upper seal for the agitator shaft. The replacement spin tube I bought does not have this seal. Is it required and is it available to buy ?
Pictures attached.
Thanks so much.
Tim

