Recent content by atomicmechanic

Sounds good, Looks like I'll need to source one, In the mean time, do you think it could cause any harm if I used a jumper to jump the terminals where the control was in order to confirm the cold control was the only issue?

TurboKinetic- So after looking at the repair manual, it is most definitely a constant cut on model. I also finally got around to putting the thermostat stonight to have a look at any of the markings after Google search I can't really find anything as a cross reference, But the manual has the...

Thanks for the reply Turbokinetic, do you know if it's possible to rebuild these thermostats or is it more feasible to just replace it with a modern one? I have the service manual if you need me to look up anything. Though I'm guessing I'll need to pull the old one to find the part number for...

So, long overdue update on the Hotpoint. After adding a bit more refrigerant, the Old girl ran great for the last 10 months or so. Up until about 2 weeks ago when it suddenly stopped getting so cold. The only thing that had change was that I dialed the thermostat down from '8' to '6'since we...

I did not, I couldn't find anything in the service manual about a filter dryer so I didn't know if it it actually had one. Where would I look for this at? Also, would the compressor be shot if it's icing over the coils inside the fresh food compartment?

So, An update on the fridge, i tested it and it was oulling about 25lbs, so i refilled with an R12 substitute (envirosafe). however im not sure that i fully evacuated the system. The fresh food section is getting plenty cold now, even icing over the coils and freezing some things that are too...

What would I need to run these tests on the compressor? I have nothing in the way of knowledge of the tools used for repairing these old fridges so you might have to be a little bit on the specific side.

I have some DIY skills, I'm a mechanical Engineering Student who fixes classic cars for fun, But I've never repaired one of these only refrigerators. I Purchased the service manual but it's only advice was to check for leaks with a Halide torch. Hopefully this David can help me find a solution!

Hey All! I Purchased this 1959 Hotpoint about a year ago ago and I recall it being cold when I bought it. But it sat in storage for a year before it was moved here. It was transported vertically (it was on it side for 30 seconds being put in the truck) and then sat for 3 hours. The main issue...