Recent content by ratan

Thank you for your advice, Coldspot66. Is the Cold Control same as Thermostat? Is it eady to replace. I know I have to take off the knob first and then take the two screws off the control box to get to the control. What do I need to do after that? I would appreciate any advice.

Thanks. I noticed that when I just tap on the cold control box/knob, refrigerator turns on. Do you think there is loose connection or I need to replace the control?

I have a Kenmore 19.0 cu.ft. refrigerator (top freezer) about 20 years old. Lately the refrigerator keeps turning off. I reset the ON/OFF from Control knob inside the refrigerator. It turns on for several hours and then again does not turn back ON. Can any one help me to diagnose the problem...

Can you please tell me where is the defrost drain line so that I can clean it? Thanks.

Thank you everyone for your suggestions with diagnosis. I will try them. Hopefully it will resolve the problem. I will let you all know.

I have a Frigidaire Refrigerator (5 Year old) and there is little water dripping on the top shelf from the cold airflow vent under the freezer in the refrigerator section on the back wall. Can anyone help me to diagnose the problem? Thank you.

I have a Frigidaire refrigidaire (4 years old). There is little water dripping on the top shelf from the cold air flow vent. Can someone help me to diagnose the problem?

I have a Frigidaire refrigerator (4 year old). There is some water dripping on top shelve right under the cold air flow vent. I was wondering if anyone can help me to diagnose the problem? Thanks.

Thank you very much Stevet for the detailed instruction. I think now I will be able to take off the lower panel and do the repair as per your instructions. I will let you know the result by Monday. Have a nice day.

Thank you Rollermatic, I look for the screws and let you know.

Thank you all very much. I can see the water valve (light blue) from underneath. I just need help finding how to take off the bottom front panel. I do not see any screws as mentioned by Rollermatic. Can someone help?

Thanks for the suggestion and diagnosis. As suggested by someone, I ran the dishwasher with the dooor open and I saw the hot water coming very slowly from the water inlet hole in left top side of the dishwasher wall near the top rack. But the water is not filling up to the desired level and...

Thanks Dave. It appears that whole cycle is working fine except for the water not filling. Hot and cold water in the sink are working. Ratan

Hi Malcolm, Inside the tub I checked the float and when I move it up and down, I here the click. I s the switch iside the tub or under the washer? Thanks.

Thank you both for your quick response. About an year ago I had similar problem and one of my friend technician has adked me to gently tap on the water valve and it started working. But this time no luck with tapping. I would appreciate if you someone can walk me through the repair - taking...