Recent content by servis-dream

Disconnect the NTC sensor. Turn the machine on while holding the start button, then rapidly press the start button 5 times and hold it, it’s the typical programming mode entrance procedure, it may have a code to enter the setting menu, try the code 125 to get in, if this does not work, try all...

Also on the subject of motors, the machine will keep its original motor It’s currently wired for a 2 speed setup, but 3 would suit it better, I may need a wiring diagram or another motor for it at some stage in the project but that’s to think about later on :))

That’s so cool, I remember that sound from the vid, first drain after mainwash Hopefully the beast works just as well on an Arduino, if not better :)) Best of luck Matthew

it feels strange for that to roll off my tongue considering the work Robert originally put into his original “Nerd Project” Super Unimatic around 15 years ago, but here comes another chapter to the lineup from none other than myself Me and my dad had an idea around a decade ago to start messing...

give AW its soul back

Reply #29 i watched it all the way through, the tub's balancing springs genuinely seem to be very innovative, along with many other features such as the machine technically not having a true outer tub, all in all it's a very interesting machine i suppose another thing you could do is film a...

lets see what it can do with the whole 9000 hehe if you have a circuit that can support it ofc, being 40 amps after all ;)

My 1999 and 2000 Miele Professional WS5073's

Replying to Revvinkevin I must admit, the Miele PW6065 was quite literally the most variable and powerful machine I had at one time Mine was an OS model (440V 60hz) that I converted to UK single Phase (240V 50hz), it had 2 heaters that pulled 4600 watts I had a few little issues with it but...

I have found this to be true My Whirlpool Direct Drive has traditional Euro spec 3/4 inch hoses, and my GOD they took a lot of effort to put on Luckily for this gorgeous specimen of a MAT12, it doesn’t appear to be the same case, as a Miele hose did thread on quite easily I think I’ll try...

a small update after breaking one of the machine's non original hoses, i do want to replace them with either some stainless steel braided or Miele Professional hoses, as both would be considered "high flow", though i am also considering actual Continental brand hoses i saw on the back of a...

after considering importing one from Cyprus because of how seemingly impossible they were to find in the UK, i stumbled across one on Ebay at a seemingly shocking £425 not many would consider a Maytag at those prices for such a seemingly "old" machine, but i suppose that's the average user, not...

so, not many of you know that i have a Miele PW6065   it's the most basic model of it's range, made in 2016, around 3-4 years before their production run ended as a whole   mine came to me as a beater, it was hauled out of a military ship and then sold on to a couple who couldn't use it, as...