Search results

OP, you should keep what you have. If you really want to replace, you should get the MVWP575GW MVWP575GW is the correct model number for the “good” Maytag that comes with a factory FULL parts and labor warranty for 5 YEARS.

Hey everyone, got a large quantity of this part the other day and was wondering if anyone knew what it is for. I know it is definitely a washer part, but that is about it.

You guys must be using the wrench incorrectly. I agree, vice grips and hammer works just fine, but the tool is mighty convenient. I wouldn’t go too far out of my way to get another wrench but I wouldn’t scrap it either.

I just changed one on an eight series washer, oddly, also a 2015. $250 minutes cost for the board. Extortion for a machine that is supposed to last 30 years?

You know they still make them? The bj series is still popular on commercial equipment. If the stem part doesn’t quite match you can just swap the rear bellow / cap tube assembly and it’s as good as new. https://amzn.to/3wvOnYw https://amzn.to/3wvOnYw

Bump Still looking for this extremely rare item. I’m willing to travel a bit for a good one.

That part has always been expensive. I think the cheapest I ever bought one was $80.

My friend Bob is taking them in. I’m doubtful he will put them in his collection but he can redo them and sell them to one of his many landlord customers

I came across this set, they came in working however the washer definitely needs some love. Belts are old and the idler is squeaky. Cosmetically the set is in “poor” condition. Only some rust on the underside of the lid but the whole set is really dirty and looks very used. I don’t know...

I’m not sure but for some reason I remember hearing that speed queen machines are pretty expensive down under. That said, it would be worth dismantling it first to see what’s salvageable. Like John said, if the agitator shaft is rotted out you’ll have to go through quite a bit to repair it...

Here is a complete kit: https://lorainfurniture.com/shop/appliance-parts/maytag-dependable-care-washing-machine-tub-seal-bearing-rebuid-kit/ This kit is the bearing (sleeve bearing) which I suppose could be a “liner” and the seal, tool, and fresh belts. If you need just the seal...

On those older tappan stoves you usually can just unscrew the orifice to allow more gas through. I’ve never seen propane orifices for a tappan and I’ve seen quite a few.

I found one on my workbench ill mail it to you

I’m guessing kenmore built by roper

I’m not sure the politics of it but quite a few 24” stack units were branded GE and were whirlpool units.

Glad I could help!

Hey call my shop , I have a good used brake bearing and a new upper bearing. Buy the top bearing and I’ll send you both. https://lorainfurniture.com/shop/appliance-parts/new-high-quality-skf-bearing-for-maytag-200720-wp22003441-ap6006364-ps11739437/

The washer during sensing mode determines the amount of amps required to spin the tub. More amps-heavier load- more water. You can try and recalibrate the washer so it can zero itself out.

I’m a big fan of warm rinse. I know it’s a waste of money/ energy but my clothes feel well rinsed and don’t give me frostbite on the way to the dryer

That direct drive washer does not have an off balance switch