Search results

More pics of under counter companion dryer.

Photos from John’s collection Sink does have a separate drain pipe.

Belt part number 5303281154, original number was Q63807

I remember working on one of those years ago, it took me a minute or two to figure how to stop it, you have to open the door! You would think they would have put a cancel button on it.

1986 Chrysler Laser Here's an article a friend wrote about my 86 Laser turbo for Old Cars Weekly Magazine.

When you tapped the coupler onto the motor shaft did you support the other end of the motor shaft? I have seen motors bearings damaged by not supporting the other end. Try removing the pump and the motor from the transmission, run the motor by itself and see if the noise is still there.

Oil smell A GE Filter-flo washer transmission is sealed and does not have a vent hole like a Whirlpool transmission, unless you have an oil leak, I don't see how you can smell the oil. My guess in what your smelling is coming from the warm motor bearings, this could explain why both washers...

The two tubes Are pilot tubes for a gas cooktop.

The damage around the roller shaft is caused by the steel wave washer behind the roller. I have seen them cut all the way thru the metal, and the shaft and roller drop off! All replacement rollers come with plastic washers to replace the steel one. Be sure not to reuse the steel washer.

Have you replaced both lid switches? The fuse is designed to blow if the two switches don’t agree with each other, and shut down the washer.

I would be happy to help you fix this if you can't do it on your own. Jeff's appliance service 301-937-6003

Check the filter The first thing to check is the filter in the bottom of the tub. If it’s dirty or clogged it will prevent water flow to the pump. This will cause the dispensers to not open.

Start device This compressor does use a PTC start device; I would not replace the comp. without trying a new one.

The clutch in the bottom of the agitator shaft is worn and slipping. You will need a new shaft.

Love laundry rule number 5!

The tabs where the pump attaches are different on the early transmissions.

Thanks for the parts list Glenn. The seal #6 is the one that's up inside the clutch drum, and may be the where the leak is coming from. If you have any water leakage, it could be coming down along the agitator shaft and into the clutch.

Oil leak The agitator shaft seal is in the spin hub that sits inside the clutch drum, any leakage will be inside the clutch, and then be thrown out into the cabinet.

Can't find any info on that model number. Can you post a photo of the washer?

If the motor stops when it should be draining, it's most likely a bad lid switch. A real model number would help.