GE Dryer problem

Automatic Washer - The world's coolest Washing Machines, Dryers and Dishwashers

Help Support :

ken

Well-known member
Joined
Jul 26, 2012
Messages
2,563
Location
NYS
Developed a problem today with our 99 GE electric dryer. Have never had a single problem with it since new. But today when I turned the knob to start all that happened was a buzzing down inside the cabinet. Tried a few times with the same result each time. Any thoughts?
 
Sounds like maybe a broken belt? The buzzing could be from the motor engaging, but without an intact belt the drum can't turn. And if the dryer is over 17 yrs old without a belt replacement I'll bet thats what it is. I replaced a belt on a Whirlpool portable dryer about 40 yrs ago, with no You Tube for support, it wasn't that hard. I think you may be able to handle this. Good Luck!
Eddie
 
Oops, then I'm at a loss. But if the motor isn't running this would be a bigger job than replacing a broken belt. Maybe if you take the back off you can get an idea of whats wrong.
Eddie
 
If it's like my 99 GE gas dryer, you pop the top, then the front front off and the motor is on the left hand side bottom.  The hardest part is getting the drum out/in because it's so bulky. Youtube is your friend.



[this post was last edited: 5/27/2017-23:05]
 
Buzzing GE Dryer

You have a bad motor, GE dryer motors are know for this. Try turning the drum by hand, sometimes the motor will start after you do this.

 

You can also hold the door switch in and hit the start Sw while turning the drum CCW to start the dryer if you need to get clothing dried. It does take three hands to this or a helper.

 

If this works you can tape a quarter over the door SW and then turn the drum with one hand while you hit the start SW. This way you can use the dryer till you decide if you want to put in a new motor or get a better dryer.
 
I had the top and front off my sisters GE dryer a few years back when I put new front drum supports in so taking this one apart is no big deal. I did turn the drum when the buzzing happened yesterday which didn't make a difference. But not while turning the knob to start. I'll give that a try and see if it runs.
 
Thanks for the info

It worked. Turned drum at same time as turning knob to start and it ran. After that it started on its own every time I tried it.
 
Back
Top