bobbyjones
Member
Hi Folks!
I have a GE GFQ14 (GFQ14ESSN0WW) Combination Washer & Dryer. It's a fantastic machine and uses condenser drying to dry the clothes (all in one). But...it's got an issue.
At some point during the drying cycle it's injecting a lot of water into the tub! So my clothes would start to get dry and then the machine would soak them. I mean soaked. This occurs intermittently but seems to be getting worse.
The machine has extensive diagnostic abilities and there are no codes of value present. Just ones you would expect in a RV, loss of power, loss of water, door latch. That was about it. So I cleared them off.
The machine has always been protected by a quality surge suppressor/line conditioner.
If I turn off the cold water inlet I can work around it.
I asked you fine folks about this last year and the suggestion was to replace the cold water control valve. So I ordered that up, installed it, and same thing
I also ordered up the WiFi module thinking there might be a firmware update but there isn't.
I'm not sure what to do next. Other than this one intermittent issue it's great. I don't want to get rid of it. I did see in reviews on the machine that someone else had the exact same issue and got rid of the machine
Many thanks in advance, it really is quite the machine and has worked really well up to now.
I have a GE GFQ14 (GFQ14ESSN0WW) Combination Washer & Dryer. It's a fantastic machine and uses condenser drying to dry the clothes (all in one). But...it's got an issue.
At some point during the drying cycle it's injecting a lot of water into the tub! So my clothes would start to get dry and then the machine would soak them. I mean soaked. This occurs intermittently but seems to be getting worse.
The machine has extensive diagnostic abilities and there are no codes of value present. Just ones you would expect in a RV, loss of power, loss of water, door latch. That was about it. So I cleared them off.
The machine has always been protected by a quality surge suppressor/line conditioner.
If I turn off the cold water inlet I can work around it.
I asked you fine folks about this last year and the suggestion was to replace the cold water control valve. So I ordered that up, installed it, and same thing

I also ordered up the WiFi module thinking there might be a firmware update but there isn't.
I'm not sure what to do next. Other than this one intermittent issue it's great. I don't want to get rid of it. I did see in reviews on the machine that someone else had the exact same issue and got rid of the machine

Many thanks in advance, it really is quite the machine and has worked really well up to now.