HELP PLEASE...Siemans error 14...

[ozzie908]

Does anyone know what an error 14 means on a Siemans WD1630 its doing my crust as it does everything to start with and a few mins into the program it beeps and comes up e14 Have tried cleaning the brushes on the motor the pumps not blocked so what can it be?

Austin

 

[bellaboy]

e 14

i think it is the heating element or thermostat fault.

 

[ozzie908]

E14

Thank you ever so for that suggestion I will give it a go its just that I do not understand why it will not spin either it starts then beeps e14...!

Thanks again

Austin

 

[ozzie908]

Bellaboy have you any more ideas ....

To share with me ?

I tried another heater and checked the thermostat still no joy starts to go then beeps and E14......ARRRGGHHH

Austin

 

[bellaboy]

e-14

if u have a multimeter u can check the heater or the thermistor , if not u can follow the wires to the main board and check if any thing is burnt. u maby need to take it apart to see under it , see for any dark spots on the main board. if u tried another heater it will not work.if i am not mistaken the thermistor is in the middle or nerby the heater this is giving a ohm or voltage to the main board so it can read the temp in the water. but if u provide me with the e-nr i can find the faulty code list foru

 

[ozzie908]

en-r

Thank you ever so much will try and fine it and let you know later !

Austin

 

[piasca]

Hi.

Sorry to take over this thread, I'm writing to bellaboy.

I need some information about buying some home appliances in Norway. Since you are from Norway and with a passion for appliances if you could give me a contact email to ask you some questions I would be very grateful.

Thanks.

 

[ozzie908]

He is in demand at present ...lol

I have the en-r number you mentioned at least I hope its the one !

en-r wd1630GB/01

Type 20052

Serial number 994040333436000802

Thank you ever so much Bellaboy

I do appreciate your help..

Austin

 

[ozzie908]

bump

Is Bellaboy about?

 

[bellaboy]

e-14

i have gone tru the wiring diagram and service modul ant it is the ntc sensor if this is a wsher -dryer it is the one in the dryer u need to replease. i eil send u the error codes

 

[ozzie908]

Your a star !

Now one more question can I disconnect the dryer on it as it's not needed?