How do I get my front cover back on? It was protruding slightly and I tried to adjust, then the other side fell. Can’t see any screws that go in anywhere, only at the bottom.
Help!
- Thread starter jil1000
- Start date
Help Support :
Attaching a Kitchenaid lower access panel
Two sheet metal screws hold this panel in place they go through the flange at the bottom of the panel into the black steel frame of the dishwasher.
You push the tow panel up behind the brackets while holding it in place and then install the two screws.
John.
Two sheet metal screws hold this panel in place they go through the flange at the bottom of the panel into the black steel frame of the dishwasher.
You push the tow panel up behind the brackets while holding it in place and then install the two screws.
John.
Have the screws…
Having a hard time finding the flange
I do however know where the screws go. I have one side in, the other is popped out. 
Should I share a picture?
Having a hard time finding the flange
I do however know where the screws go. I have one side in, the other is popped out. Should I share a picture?
Those lower panels can be exasperating to install. My experience has been to keep trying and eventually it pops into place when you least expect it.
Exasperated
Haha yes they are. The one side that started it all popped back in and now the other side is popped out- go figure. It might be staying like that until my new unused KDS 18 arrives next week.
Haha yes they are. The one side that started it all popped back in and now the other side is popped out- go figure. It might be staying like that until my new unused KDS 18 arrives next week.
Maybe this will help...
I responded on your other post but you might have missed it.
I responded on your other post but you might have missed it.
