Hoover Ecologic A3954

[mikeymatic]

Gentle tumbling

The wool theory - it's gentle tumbling all the way through the cycle but it does reach 1200 on the final spin. I did press the wool button mid-cycle but it still tumbled on gentle.

I'll get some Servisol and have a go at cleaning the switches.

Thanks for tips.

Mike.

 

[hoovermad]

I have a Logic 1200 washer/dryer that does exactly that. Still washes well even though it does delicate tumbles on all programmes.
I did look into it a bit and from what I could tell there were a few machines made with rouge timers that did this as normal. Must admit I didn't believe it when I found out but as yours does the same then maybe. . .

 

[optima]

Logic

Does it spin in between the cotton rinses.

 

[mikeymatic]

Spin

It does 1 spin between cotton rinses.

 

[hooverzanmiele]

Sequence Of Cycle

Hi Mikey,

The usual sequence of the cycle for Cottons would be:

Fill.
Heat
Wash
Cool-Down.
Wash-spin (095RPM)
Rinse 01.
Rinse-Spin 01 (095RPM/500RPM).
Rinse 02.
Rinse-Spin 02 (095RPM/500RPM).
Rinse 03 (Softener).
Spin Dry (095RPM/0800RPM & 1200RPM)in the case of the A3954.

I've attached the link of my A8576 1250RPM washer dryer, which features the wash-spin through to the end of the final rinse.

Showing spin dry 1250RPM until 8:19


Hope this will be of use to helping you sort the A3954.

CJ

http://https//www.youtube.com/watch?v=Mvk0X0igZG8

 

[jottapee]

Hoover Computer Logic 1300

Olá a todos, boa tarde de Portugal

Novo por aqui!

Tenho uma máquina dessas e estou à procura de um manual em PDF.
Será que me podem ajudar?
Está parada desde 2007, parece estar tudo em ordem menos o motor que precisa de atenção. Quando tento ligar aparece a mensagem de erro "F6".

Gostei do post do Gary em 2010, vou tentar seguir os passos dele.

Obrigado pela atenção

PS: Caso seja possível enviem para o meu email: [email protected]

João Lopes

 

[malcolm1]

A3954 Drum Bearing Kit

Hi All

Am new to the group so wanted to first say hello.

I’ve had a A3954 Washer since 2004 and it’s needed very little work but lately it’s started to need more attention (not surprisingly really). It wasn’t spinning at full speed. Changed the brushes which fixed that but at the time I noticed some slack in the drum indicating the bearings probably should be changed. Does anyone know where they can be obtained and the steps required to do the job?

Many thanks for any help.