Hi all, i'm enquiring for some advice on my 5 year old Miele Distinction 3000 washing machine. I've never had any problems with it but over the last few weeks i've noticed the fabric conditioner compartment isn't draining left-over water properly, i thought this may be due to a clog so thoroughly cleaned the drawer out, taking it completely to bits and scrubbing everything, even the syphon tube. However, this has made no difference. This wouldn't be a major problem but once I've put conditioner in for the cycle and close the drawer, i have to be VERY careful as the motion of the drawer closing with all the liquid in can cause the syphon to, well, syphon and i lose the conditioner into the wash load before the machine is even switched on.
I've also noticed that the 'finger holes' you use to pull open the conditioner flap and that let the water into the compartment during the final rinse are surrounded by fabric conditioner after the cycle has finished so it seems the compartment is overflowing slightly before the syphon kicks in.
Also...
Today i did a load of bedding, i did the usual routine of carefully loading the conditioner and ensuring the drawer was closed very carefully but upon unloading the bedding i noticed it smelt rather...well, unpleasant (worse than it did when it went in, so i know it's not me
) This forced me to run it through another rinse with some more conditioner, when it came out again it smelt slightly better but nothing like it normally does.
I pride myself on knowing the ins and outs of my washer but this has got me stumped. Any help you guys can offer?
Pedz
I've also noticed that the 'finger holes' you use to pull open the conditioner flap and that let the water into the compartment during the final rinse are surrounded by fabric conditioner after the cycle has finished so it seems the compartment is overflowing slightly before the syphon kicks in.
Also...
Today i did a load of bedding, i did the usual routine of carefully loading the conditioner and ensuring the drawer was closed very carefully but upon unloading the bedding i noticed it smelt rather...well, unpleasant (worse than it did when it went in, so i know it's not me

I pride myself on knowing the ins and outs of my washer but this has got me stumped. Any help you guys can offer?
Pedz
