bigterkc
Active member
Does this look right?
So, I've finally got a little time and cleaned around on the A806 and ran it through a cycle, and everything seems to run fine as far as agitation/spin and settings. But I noticed the Bleach Dispenser didn't let water (I tested it with water) flow into it. So, I popped off the front panel and took a look at it, removed the hose from the dispenser and tried to blow into it, but air wouldn't pass.
The machine had some MAJOR hard-water build up that I removed from under the agitator and lint filter, and when I took off the bleach dispenser hose it was gunked up with calcium build up. I picked around at it, but it's not wanting to come out and it looks like there's something else in the hole.
SO, I took a picture and will post it here.
My question is: Where the hose connects to the outer tub, is there any type of insert that goes in there to slow down the bleach dispensing, or is it just totally gunked up and needs a good reaming?
Thanks for any replies.
Terry

So, I've finally got a little time and cleaned around on the A806 and ran it through a cycle, and everything seems to run fine as far as agitation/spin and settings. But I noticed the Bleach Dispenser didn't let water (I tested it with water) flow into it. So, I popped off the front panel and took a look at it, removed the hose from the dispenser and tried to blow into it, but air wouldn't pass.
The machine had some MAJOR hard-water build up that I removed from under the agitator and lint filter, and when I took off the bleach dispenser hose it was gunked up with calcium build up. I picked around at it, but it's not wanting to come out and it looks like there's something else in the hole.
SO, I took a picture and will post it here.
My question is: Where the hose connects to the outer tub, is there any type of insert that goes in there to slow down the bleach dispensing, or is it just totally gunked up and needs a good reaming?
Thanks for any replies.
Terry
