New Hotpoint 1504 toploader

[sesteve]

And front

 

[sesteve]

top removed

 

[sesteve]

close up of fill spout. I said previously that the bowl did not have an overflow but there is one in the previous picture located at the front

 

[sesteve]

Water fill from console

 

[sesteve]

drive nut

 

[sesteve]

removed

 

[sesteve]

top seal removed - note the lack of a bowl clamp on these models

 

[sesteve]

Bowl out

 

[sesteve]

You can see the pocket for the thermostat phial here

 

[sesteve]

close up of the bearing race

 

[sesteve]

underside of bowl showing seal glued in place

 

[sesteve]

on its side

 

[sesteve]

base showing the bottom horizontal support. This is the bit that has to be adjusted to ensure smooth running

 

[sesteve]

Bar removed

 

[sesteve]

gearbox removed

 

[sesteve]

view of lid through machine!

 

[sesteve]

Surgery almost complete

 

[sesteve]

Back together and working again

 

[sesteve]

Just watch out for the rate it pumps out!!

 

[sesteve]

complete with lamp in the timeline as the original version had and a suds cake developing. Hope these are useful

S