Hi Launderess
I have emailed you too and not got a reply - don't know what's going on out there in cyberspace.
I have your pump ready to send, have your address from an email that did get through a week or two ago.
The reason I emailed you - I also have a rubber drain hose if you want it. It is to suit an AU spec machine, where the hose exits the machine through the back panel, not the top. It should still fit, though you might want to cut off the end which is shaped to fit the rear panel opening. It is somewhat longer than the top exit hoses used on older machines and US spec ones. I personally think that you may be better sourcing a generic drain hose locally, but I can enclose this one, it is in good used condition, not sure what it will add to the postage cost.
I also have a rubber spin mat if you want it, and a couple of belts - the elasticated stretch belt for the pump and the fine v-belt for the spinner. The AU model appears to have a different motor so the belts might not fit but I am happy to enclose them in case they are suitable, if you'd like.
As you have offered to reimburse postage, which I appreciate, it is up to you if you'd prefer me just to send pump and castors, which will be cheaper, or enclose a few extra bits and pieces. A neighbour gave them to me when he replaced his Hoovermatic with a new cheap Chinese automatic washer. Some of the parts are brand new.
As soon as you reply I will send the bits and pieces. You might as well reply here as we don't seem to be communicating by email very successfully.
Best Wishes
Chris.