Whirlpool Duet Washer Problems

[simplicity345]

I Have A Whirlpool Duet Washer Model # GHW9100LW2 And After It Runs For Some Time It Gets A Water Issue Problem Code FH Or F And H If Any One Knows The Problem Please Email Me @ [email protected]

Thank You
Mark M

Note: This Washer Is A Front Loader

 

[cfz2882]

how far up the window does it fill? I had one that would overfill about 1/3 up the window,give error code(FH IIRC)and shut down-cause was pressure switch hose had came unclipped,flopped against outer tub and had a hole worn in it.Also the drain pumps on these wear out and become erratic in operation.The pump trap could be plugged too.

 

[gansky1]

FH is a no water level switch trip error code.  This can be caused by a few problems ^ as mentioned in the first reply.  You might first check the water inlet screens to see if they're plugged, a fairly common problem.  clean out the screens, flush the hoses and reconnect.  If it's still giving you the error code and lines are clear, you may have to move on to checking the solenoid valve itself.