natalie
New member
It's fixed!
Husband successfully hot wired the machine using directions from the internet! Make sure the machine is unplugged. He put a jumper between pins 1(purple) and 6(yellow) of CONN3. This shorts out the door lock spin enable switch and will allow it to complete the cycle. Now take off the front plate of the machine by opening door, remove 2 screws left and right, and pull off front plate. Now top will pop up. Remove the two wires on the right sensor and connect together with a piece of wire and tape each joining. Before putting everything back together, check and see if the drum spins up to a whistle. It should work! The lock light still will not come on, but the machine will finish a cycle. The only thing to remember after that is that the door is NOT locked and could open! So keep an eye on the machine!
Husband successfully hot wired the machine using directions from the internet! Make sure the machine is unplugged. He put a jumper between pins 1(purple) and 6(yellow) of CONN3. This shorts out the door lock spin enable switch and will allow it to complete the cycle. Now take off the front plate of the machine by opening door, remove 2 screws left and right, and pull off front plate. Now top will pop up. Remove the two wires on the right sensor and connect together with a piece of wire and tape each joining. Before putting everything back together, check and see if the drum spins up to a whistle. It should work! The lock light still will not come on, but the machine will finish a cycle. The only thing to remember after that is that the door is NOT locked and could open! So keep an eye on the machine!
