Beko WMA7247 Stalling mid cycle

[aegokocarat]

Hello,
Since the start of the month Ive been using my beko washing machine every week (4 loads all done on a Saturday or a Friday), today I started the machine on a short 40*c to freshen up a throw and the machine got to the first rinse and it stalled as it was about to spin and did nothing (and it didn't over foam), then I put my normal wash load in on a cottons 40*c wash and that did the same as well!, it first started doing it at the beginning of the month and I just passed it off as a power surge but now Im starting to think that the PCB might be developing a fault.
Help appreciated
Tom

 

[aegokocarat]

Woops! that should be "WME" in the title!

 

[iheartmaytag]

Are you getting any fault codes? It almost sounds like a pressure switch. MY Maytag Fl did that, but would throw an oversud, or F35 error. Service replaced the pressure switch, problem solved.

 

[aegokocarat]

Im not getting error codes at all, it will drain the water after the first rinse and just sit there and do nothing
Tom