Decent Online finds
- Thread starter classiccaprice
- Start date
Help Support :
classiccaprice
Well-known member
Lighted Control Maytag Set
With GE Range in PA[this post was last edited: 4/15/2013-20:51]
With GE Range in PA[this post was last edited: 4/15/2013-20:51]
classiccaprice
Well-known member
That may be a 1965-ish Whirly dryer. Looks in very good condition, but pics can be deceiving.
That Whirlpool dryer looks very well taken care of. By the appearance of the drum, it has evidence of very low use too. Owner probably used the clothes line much more than the dryer.
That early 806 Maytag washer still has the original style agitator. Better hope it never needs to be removed. Dryer should have the early wirewound baffles if it hasn't been upgraded to the newer style.
That early 806 Maytag washer still has the original style agitator. Better hope it never needs to be removed. Dryer should have the early wirewound baffles if it hasn't been upgraded to the newer style.
WP and MT Dryer
That WP dryer is the last of the 2 speed blower models, probably built in 1965-6. Dan didn't the first Power-fin MT agitators still have a replaceable aluminum spline ?, I know they can get stuck but if the agitator comes out without the spline a new one can be installed. The ad for these MTs says the dryer is 1972, it should have the bar style sensor baffles by this time.
That WP dryer is the last of the 2 speed blower models, probably built in 1965-6. Dan didn't the first Power-fin MT agitators still have a replaceable aluminum spline ?, I know they can get stuck but if the agitator comes out without the spline a new one can be installed. The ad for these MTs says the dryer is 1972, it should have the bar style sensor baffles by this time.
whirlcool
Well-known member
That Hamilton dryer looks like it was used outside on the back porch.
Dan didn't the first Power-fin MT agitators still have a
Yes, that's correct. The same A4731 spline used on the E/J/N wringer agitators. The spline can be had by Phil, but finding someone with the tools and knowledge to extract and install the spline might be a bit of a chore.
<a name="start_46053.673069">The ad for these MTs says the dryer is 1972, it should have the bar style sensor baffles by this time.</a>
Whoops, I didn't even read the ad. I assumed the dryer was a match to the washer through and through.
Yes, that's correct. The same A4731 spline used on the E/J/N wringer agitators. The spline can be had by Phil, but finding someone with the tools and knowledge to extract and install the spline might be a bit of a chore.
<a name="start_46053.673069">The ad for these MTs says the dryer is 1972, it should have the bar style sensor baffles by this time.</a>
Whoops, I didn't even read the ad. I assumed the dryer was a match to the washer through and through.
