rishrash
New member
I have a Speed Queen AFN51F (Stainless steel front load) that has a door leak at the bottom. It was purchased new in 2014, so 5 years old). The leak has been intermittent for about a year, but seems to have gotten worse. The glass is very clean with no residue or scratches. No hairs or other things to break the seal.
The gasket does have a weird wave or ripple where it contacts the glass. I have attached a pic that sort of shows it. I am not sure if this alone is causing the leak.
The door does have some free play or movement at the bottom. When it is closed you can push it in another 1/16"- 1/8". Is there some way to adjust the door? I have looked at the latch and the hinge and I don't see any way to adjust it to be tighter.
I am willing to replace the whole door gasket/boot, but it is expensive (~$140) and I would like to try tightening up the door first if that is possible. It really seems like the door not closing tight enough is the issue.
I appreciate any thoughts or comments. Other than this minor issue the SS front load washer/dryer combo has been great equipment, zero issues.


The gasket does have a weird wave or ripple where it contacts the glass. I have attached a pic that sort of shows it. I am not sure if this alone is causing the leak.
The door does have some free play or movement at the bottom. When it is closed you can push it in another 1/16"- 1/8". Is there some way to adjust the door? I have looked at the latch and the hinge and I don't see any way to adjust it to be tighter.
I am willing to replace the whole door gasket/boot, but it is expensive (~$140) and I would like to try tightening up the door first if that is possible. It really seems like the door not closing tight enough is the issue.
I appreciate any thoughts or comments. Other than this minor issue the SS front load washer/dryer combo has been great equipment, zero issues.

