2packs4sure
Well-known member
I'm doing the wash and realize that it's not agitating, short version is the motor never responds at all, wash or spin.
When I select drain and spin the drain pump runs then the main user control area clicks then a second or two later the inverter board clicks the motor doesn't even twitch then the process starts over.
I noticed the door latch doesn't latch for spin but maybe that's because it hasn't sensed motion...
No error codes displayed.
Unless someone knows from experience what the issue is I wanted to start at the motor and check for proper voltages but I need to know what to look for.
The motor plug has 6 wires ~ Yellow Orange Blue White Black Green.
I have motor, inverter, and backsplash user controller part #'s at the ready if needed..
Any help, guidance, factory schematics, and/or service info. would be greatly appreciated.







When I select drain and spin the drain pump runs then the main user control area clicks then a second or two later the inverter board clicks the motor doesn't even twitch then the process starts over.
I noticed the door latch doesn't latch for spin but maybe that's because it hasn't sensed motion...
No error codes displayed.
Unless someone knows from experience what the issue is I wanted to start at the motor and check for proper voltages but I need to know what to look for.
The motor plug has 6 wires ~ Yellow Orange Blue White Black Green.
I have motor, inverter, and backsplash user controller part #'s at the ready if needed..
Any help, guidance, factory schematics, and/or service info. would be greatly appreciated.






