mrlaundry1011
Well-known member
Does anyone know if Miele little giants have programming mode? The usual 5 press and hold of start doesn’t work, but service mode does (3 press and hold)
Miele little giant programming mode
- Thread starter mrlaundry1011
- Start date
Help Support :
They should I would think.
However, there could be a lock on it. The setting menu on these is usually locked with a code and that might keep you from accessing the programming menu.
Or Miele has completely locked that out for the Professional machines.
On these, you can have the machine on and start the procedure by closing the door I think.
So open the door with the machine on, hold start, close door, same procedure from there.
However, there could be a lock on it. The setting menu on these is usually locked with a code and that might keep you from accessing the programming menu.
Or Miele has completely locked that out for the Professional machines.
On these, you can have the machine on and start the procedure by closing the door I think.
So open the door with the machine on, hold start, close door, same procedure from there.
mrlaundry1011
Well-known member
I think it’s been blocked - tried again but 5 press version doesn’t do anything. But 3 press service mode works fine. Good job the access code was left as 000 default
richnz
Well-known member
On the older machines
One had to disconnect the temperature sensor from the pcb before programming mode could be entered
One had to disconnect the temperature sensor from the pcb before programming mode could be entered
For the little giants, aren’t the programming options detailed in the manual? Or has it been dumbed down in the latest generation.
The manual I am seeing on Miele's homepage says a cog symbol will appear when you set the dial to Drain/Spin.
mrlaundry1011
Well-known member
Is supervisor level the same as programming mode for the little giants? I was expecting to see a heater rating option considering this model can be 13amp or 25
